This fish is so quickly and easily formed that it can be done even by a primary school student. Preferably with the help of an adult. Should someone show the child how to gently fold the sheet and bend the corners. Such a fish can be hung by a thin, inconspicuous thread to the chandelier or glued with adhesive tape to the wall. And then she can become a talisman for the child. After all, it is so similar to the Golden Fish from a fairy tale! The sequence of work. To fold such a fish, prepare a sheet of yellow paper. From the seamy side the paper should be white.Fold the upper right corner of the sheet in half diagonally with the wrong side inwards. Cut off the part of the sheet that is left.Expand the leaflet. You got a square with a single diagonal bend.Fold a square along another diagonal.The fold must be on top.The sides of the triangle bend downwards, aligning the side corners with the bottom. Two moving triangles turned out.These triangles fold in half horizontally.At the top again we got two triangles. Bend them in half and unbend again. Folds defined their middle.The upper parts of the triangles again fold in half, aligning their sides with the midline.Two sheets in the form of triangles turned out at the bottom of the craft. One of the triangles is bent upward by 3/4 of its height. Fold press.Take hold of this fold and fold again up,making a bend exactly in the center of the craft.You have a square on which all the work done by you was at the top. And at the bottom there was a single triangular leaf. In the middle of the blank on this triangle, make a label on both sides at a distance of 1 cm from the center. On both sides make notches before the marks.The lower triangle is bent behind the hand-craft. You will get such a pilot's cap. Uncover it wider. Take the bottom of the side corners and connect the right side of the cap to its left side, simultaneously cutting part of the craft on the right. Holding the hand-made article in half-opened form, fold the tail part of it along the fold with the white side inward.Turn the right triangle (tail) 90 degrees upward so that its base takes up the vertical position. Top slightly in the area of the incision slightly push into the crafts.